Castle Creations 1010-5600kv 4 Pole Sensored Brushless Motor, 060-0099-00

Out of stock

Castle Creations 1010-5600kv 4 Pole Sensored Brushless Motor



  • Ideal for 1:16 and 1:14 scale vehicles running up to 3s LiPo
  • Our IMPROVED 4-POLE 12-SLOT design boasts exceptional EFFICIENCY and produces LESS HEAT
  • QUIETSENSE™ technology shields the sensors from magnetic field noise generated from the motor coils and keeps your motor and ESC in sync at all times. Use of a Flux Shield™ in conjunction with secondary Sense Magnets delivers even HIGHER PRECISION and MORE EFFICIENT startups
  • Our OPTIMIZED design eliminates the need for mechanical timing adjustments. Our sensor alignment method delivers uniform timing and torque in both directions, automatically
  • REBUILDABLE design allows users to replace front end bell/bearing assembly or rotor/shaft assembly
  • ROAR standard sensor port and labeled connections
  • Updated modern and sleek design; looks as cool as it performs
You're reviewing:

Castle Creations 1010-5600kv 4 Pole Sensored Brushless Motor, 060-0099-00

Your Rating

Product Information

Drivers in all applications demand clean starts when coming off the line. Crawler fans require high-precision low speed control and torque for climbing, racers need precision and predictability, and dragsters don’t have a millisecond to spare. To achieve all of these performance demands and more, we have integrated rotor position sensor technology with our improved high power and high efficiency motor design. Through the use of our sensors, the position of the rotor is always known by the ESC. This eliminates the possibility of encountering cogging or inconsistency during startup. Users will experience PRECISE throttle control and BUTTERY SMOOTH starts plus the RAW POWER and LONGER RUN TIMES that our highly efficient motors produce.


Input Voltage Range:
2s - 3s LiPo
Max. RPM:
Length: 58.4 mm
Diameter: 28 mm
Weight (w/wires):
5.17oz (144.6g)
Shaft Size:
Length: 15 mm
Diameter: 1/8"" (3.175 mm)
Mounting Hole Specifications:
M.5 @ 14mm & 16mm; M3 @ 19 mm
4mm male Castle Bullet Connectors attached to replaceable 16 gauge wire; includes 210mm length sensored wire
Items Needed for Operation:
Compatible Electronic Speed Control (ESC)
Application Guidelines:
Ideal for 1/16th and 1/14th scale vehicles weighing up to 3lbs.
Recommended ESC(s):
Mamba Micro X2
Running Modes:
SmartSense™ (with Castle Sensor capable ESC), Sensored and an ultra-efficient Sensorless mode.
Tech Notes:
Water Resistant Design: The sensor board is coated with silicone conformal coating to protect the sensors from moisture. The sensor connections are not water resistant; water can cause signal loss which could result in loss of sensored capabilities. Castle recommended applying dielectric grease to the outside of the sensor wire connections after installation of the wire. Routine maintenance is recommended after running in wet conditions.