E-Flite 80Amp Pro SwitchMode BEC Brushless ESC, EC5 (V2)
When performance matters in your high-current applications, look no further than the E-flite® 80-amp Pro switch-mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 80 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic end-caps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range and more, the E-flite 80-amp Pro switch-mode ESC is truly a ‘pro series’ electronic speed control.
Looking for spare parts or upgrades?
Features
- Up to 80 amps continuous current and 100 amps burst current (15 seconds)
- 5V switch-mode BEC capable of 5 amps continuous current and 6 amps max burst
- Can run up to 7 analogue or 6 digital standard-size servos with the BEC
- 3- to 6-cell LiPo, 9- to 18-cell NiMH/NiCD input voltage
- Motor braking is programmable
- Safe power-arm mode
- Programmable low voltage cutoff
- Programmable throttle input range
- Programmable soft start-up rate
- Automatic motor shut down if signal is lost or there is interference
- Programmable timing with user-selectable ranges
- Two operating modes
- Pre-wired connectors
Reviews
Product Information
For high-current models, the 80-Amp Pro Switch Mode ESC from E-Flite is the ideal choice. This sensorless brushless speed controller comes with an integrated switch-mode BEC and can operate without a separate battery to power your servos and receivers. It offers up to 80 amps of continuous current when using 3- to 6-series LiPo batteries. You can also run up to 7 analogue or 6 digial standard-size servos with the BEC on any recommended input voltage. This ESC is housed in an exposed, finned heat sink aluminium case with lightweight plastic end-caps. It offers safe power-arming along with advanced programmable features, including low voltage cutoff, braking, timing and throttle input range. Order yours now.
Specs
- Forward
- Yes
- Brake
- Yes
- Time Delay Brake
- Yes
- Continuous Maximum Current
- 80A
- Input Connector Types
- EC5, 10AWG
- Output Connector Types
- 4mm gold bullet, 12AWG
- Momentary Peak Current
- 100A (15 seconds) Proper Cooling Required
- Length
- 3.0 in (77mm)
- Width
- 1.6 in (41mm)
- Height
- 0.62 in (15.5mm)
- Weight
- 3.75 oz (106 g)
- BEC Voltage
- 5.5 Volt switch-mode
- Overload Protection
- Yes
- Wire Gauge
- 10 awg input leads; 12 awg output leads
- Cells w/BEC
- 9- to 18-cell Ni-MH, 3–6S Li-Po
- Auto Cutoff
- Yes
Product Manuals
All product manuals are provided by the manufacturer, If you don't find the manual or information you are looking for, contact our experts for help.