Article: JR Synthesized Receiver

Setting the frequency on a JR PPL Synthesized Receiver

You can set the frequency in the receiver by following these instructions:

1. Plug a battery into the RS70 receiver and turn power on.
2. Turn on the transmitter and place it 1 metre from the receiver.
3. Press and hold down the “SCAN” button on the end of the receiver for more than 2 seconds.
4. Release the “SCAN” button for 2-3 seconds, then press the “SCAN” button again for ½-1 second.
5. The LED will flash on and off quickly during the scanning process and once this process is completed the LED will stay solidly lit.

If the LED flashes slowly then there has been a problem with the scanning procedure and you should repeat the procedure after checking that the receiver battery has sufficient voltage and that there are not any other transmitters in the close vicinity of your receiver.

These instructions are applicable to the following JR receivers:

	[JRPRS70] RS70 - 7 channel micro synthesising FM receiver. 18gr, 36 Mhz. Never buy crystals again. just dial up your frequency. And its only $20 more than the JR R700! How to set the frequency Note: 36MHz only

	How to set the frequency   [JRPRS77S] RS77S - 7 channel synthesising PCM receiver. 36 Mhz. Never use crystals again! Dial up any frequency in the 36Mhz range instantly. best of all, its only $21 more than the standard R770S making it revolutionary as well as great value! Note: 36MHz only